Move application requirements to FAQ

docs/FAQ.md

@@ -1,5 +1,7 @@
 # FAQ
 
+
+* [Application requirements](#application-requirements)
 * [Why are the settings "not saving"?](#why-are-the-settings-not-saving)
 * [Can I use the same USB install media as a universal installer?](#can-i-use-the-same-usb-install-media-as-a-universal-installer)
 * [Can I use OTA updates?](#can-i-use-ota-updates)
@@ -11,6 +13,15 @@
 * [Where is Apple Intelligence?](#where-is-apple-intelligence)
 
 
+
+## Application requirements
+The patcher application requires **OS X Yosemite 10.10** or later to run.
+* **OS X El Capitan 10.11** or later is required to make installers for macOS Ventura and later.
+
+The patcher is designed to target **macOS Big Sur 11.x to macOS Sequoia 15.x**.
+* Other versions may work, albeit in a broken state. No support is provided for any version outside of the above.
+
+
 ## Why are the settings "not saving"?
 
 OpenCore Legacy Patcher is a config build tool and as such the user interface always reverts to safe defaults, the user interface therefore **does not** reflect the status of settings. Settings are accounted for and saved by the OpenCore building process and you will always have to build OpenCore again after settings change. 

docs/MODELS.md

@@ -1,14 +1,5 @@
 # Supported Models
 
-### Application requirements
-The patcher application requires **OS X Yosemite 10.10** or later to run.
-* **OS X El Capitan 10.11** or later is required to make installers for macOS Ventura and later.
-
-The patcher is designed to target **macOS Big Sur 11.x to macOS Sequoia 15.x**.
-* Other versions may work, albeit in a broken state. No support is provided for any version outside of the above.
-
--------
-
 Any Intel-based Mac listed below can install and make use of OpenCore Legacy Patcher. To check your hardware model, open System Information and look for the `Model Identifier` key.
 * This applies even if Apple supports the model natively.
 * OpenCore Legacy Patcher does not support PowerPC- or Apple Silicon-based Macs.